Thread: 10 bolt chevy rear end question

Tweet

This is great,, I just got another call from my machinest and he told me that the aluminum heads I bought are a differant configuration from the iron heads I had, and it looks like with the longer valves etc I have to purchase a new set of pushrods I am going over there after work and if I have tme I will pop the cover and get some pictures of the ring gear and what not to post on here so mabey you guys can help me tell if I have bad or good set up.

thanks again esp for the pictures and suggestions

Originally Posted by chpseat987

This is great,, I just got another call from my machinest and he told me that the aluminum heads I bought are a differant configuration from the iron heads I had, and it looks like with the longer valves etc I have to purchase a new set of pushrods I am going over there after work and if I have tme I will pop the cover and get some pictures of the ring gear and what not to post on here so mabey you guys can help me tell if I have bad or good set up.

thanks again esp for the pictures and suggestions

get a size on push rods i maybe can help you out i have some smith brother push rods if needed

Thanks Pat I will, After getting home from the machine shop yesterday and the questions and help i got about my rear end, i decided to pull the cover off, and I was pissed.. the pinion gear clim's up the ring gear before it moves it around its sloppy, there are heavy scars on both ring and pinion and more scars on the spider gears and the center pin looks like it was hand ground with a die grinder dam neart in 1/2. So I am out looking in the sites today for a bolt in 12 bolt with 4:56's. Any suggestions?

Originally Posted by chpseat987

Thanks Pat I will, After getting home from the machine shop yesterday and the questions and help i got about my rear end, i decided to pull the cover off, and I was pissed.. the pinion gear clim's up the ring gear before it moves it around its sloppy, there are heavy scars on both ring and pinion and more scars on the spider gears and the center pin looks like it was hand ground with a die grinder dam neart in 1/2. So I am out looking in the sites today for a bolt in 12 bolt with 4:56's. Any suggestions?

put a 9 inch in it

Will it bolt in easy or will I have to make several modifications? I have ladder bars and stock spring mounts.