Well I've been pretty sick the last few days, and it's -30 degrees C so needless to say I'm getting pretty bored. I was going to put my front axle from Speedway together so here's some more questions.

First this is the kit:
http://www.speedwaymotors.com/p/3302...-Spindles.html
That has the only instructions and I've never done this before either.

Which side is up on these bearings:
http://www.flickr.com/photos/12817213@N06/2232271554/
and why do I have 4 shims when it only shows one on each side??

This is the order I get with the right being the top:
http://www.flickr.com/photos/12817213@N06/2231478895/

The middle discs are convex so I'm assuming they would curve into the kingpin, they're also a little big so do these get pressed in?? Next on the top and bottom are what I think are dust covers, these are loose and have no way to hold them in place, any ideas???

Finally, what are these, steering stops???
http://www.flickr.com/photos/12817213@N06/2231478471/
Do they go into the holes shown in the kingpin housing where the small allen key is???

I thought this would be easy until I took a closer look.

Thanks,
Sean