Thread: I need some help here...
-
01-23-2008 08:22 PM #1
I need some help here...
After taking part of the steering column apart in the boys car, the 'new' column from the salvage, to tighten up a couple of bolts in it. Now I am having trouble getting the high/low beam headlight switch working right. Does anyone on here happen to have an exploded view of that column? I don't think that I have the little slider that is actually behind the tilt lever set in there right, and it will not trip the switch when pulled in the first place.
Info: 89 Chevy Celebrity; column shift auto.
Any help with this would be greatly appreciated.
I posted this here because I know that this will be seen easier by more folks on here than lower on the front page.
Jim B .Gunmetal Grey 88 TC, 2.3L 4-cylinder Turbo, Ranger Roller cam, adj. cam gear -4*, T3 Garrett Turbo (0.48 hot side/0.60 cold side), Spec Stg. III clutch, 79 Pinto oval port head (mildly ported with over sized valves), gutted upper and knifed lower, Super Coupe Throttle body, and a few other mods.
Running 17# of boost and loving it, though looking for more!
Later a Big NPR FMIC and Holset Turbo
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
01-23-2008 09:50 PM #2
Thanks so much, now I think that I can get the thing back together again.
Thanks again.
Jim B .Gunmetal Grey 88 TC, 2.3L 4-cylinder Turbo, Ranger Roller cam, adj. cam gear -4*, T3 Garrett Turbo (0.48 hot side/0.60 cold side), Spec Stg. III clutch, 79 Pinto oval port head (mildly ported with over sized valves), gutted upper and knifed lower, Super Coupe Throttle body, and a few other mods.
Running 17# of boost and loving it, though looking for more!
Later a Big NPR FMIC and Holset Turbo
As a hobby I keep ten beehives. My queen bees are now getting older and slowing down, so I ordered ten more queens from an apiarist. They arrived, but there were eleven arrived in their containers....
the Official CHR joke page duel