Boy it would be nice if they offered welding classes around here with times that didn't coincide with work!
After all day yesterday, cuting, grinding, welding it looks worse but I beieve it's better! There were two areas of the window channel with rusted through holes. One unfortunately is right underneith the drivers side windshield motor mount, so I was limited in what I could weld as a backing plate from the underside, but I think if I use some fiberglass inforced bondo with the plate under there as support it should be alright. The othere side I was able to get some substancial metal under the thin rusted sheet metal at get some good adhesion to solid metal. It looks like somebody gave Frankenstein a welder and grinder, but body filer will hide that. Today I have to do some volunteer work but hope to get an hour or two to work on it afterwards. Then I have the whole week to get the motor back in! All in all things still going as planned but slower than planned! :)
Was wondering if anyone has a unilite distributer, and if they have ever removed or replaced the light module? I figure I've got quite a bit of welding to do on the frame, and t would be nice to remove the module(welding can ruin it if it's in the car while you weld on it) while welding, then put it back when done. I haven't played much with it other than the installing of the distributer.