hi guys, I have a 350 block and a good set of 416 casting 305 h.o. heads they are 1.84/1.5. ported/polish/and gasket matched.
I posed this question on another board, but was only told they dont flow as well. so here goes,these heads on a 350 will create around 10.5 to 1 compression, so therefore what is the result???I understand that they dont flow as well as say 882 castings, but at 10.5-1 would these heads produce a torquey bottom end?how limited would the top end be??would it have lots of power on take off , then loose it at say 4000 rpm?? or would they just suck??
the plan is for a lowered chev s-10 truck , mainly just a tire screecher, If i want to go fast i'll drive the vette.what I want is lots of ball$ pulling away fishtailing up the road.will this be the result?? or will it just suck?? mike