Printable View
Hi guys, I have been assembling the A and have come accross an interesting issue. Most of the items I have purchased over time have not come with gaskets. What I am talking about is the small cardboard or cork items that go bettween the panelwork and the item. (door handles, door locks, headlight staunchions, taillights etc) My question is, is there a site out there that has these templates I can print off and use to make a template for a gasket...?
Thanks heaps,
Web.
For what they cost, i'd just buy new ones and be done with it...but this is of course just my opinion. I was just looking at the link below for things such as the rubber pad thing that goes between the outside doorhandle, and they are $3 for both. Radiator pads are like $2.75, and the rubber "stoppers" for the door are $3 each. For next to nothing, you can have it shipped to your house in a few days, pre-cut, pre-made, and ready to go. Probably cheaper than a couple pairs of holepunches. If they were not available, it would be time to get creative, but not when they are so cheap and accessable.
http://www.midwestearlyford.com/midw...shopbrowse.htm
HTH,
Greg
Thanks for your help guys, ended up just using an old breakfast cereal carton and some soft very thin insertion rubber, looks good too. (if I do say so myself:D ) I think for any more I will do the same. Takes a while, but hey, we got buckets of "whiles" hey guys.....????:3dSMILE: