Thread: valve tool questions
Results 1 to 15 of 19
LinkBack URL
About LinkBacksThreaded View
-
02-07-2005 08:08 PM #4
CHR Member
- Join Date
- Apr 2003
- Location
- Holly, Mi.
- Car Year, Make, Model: various 1924-91
- Posts
- 223
You can use stones to cut the seats. The factory uses special profile cutters to do the job. I use a Serdi, but for what you are doing a stone setup will do just fine...
I would assume that the valve grinder you have is made by Kwik-Way, Souix, Sunnen or one of the other manufacturers and re labeled Snap-On. I know they do that on a lot of their specialty tool stuff.
For a look at the profile cutters go to www.newaymfg.com I use their cutters for small engines. Kholer, Kawasaki, Briggs&Strugglin etc.
Also try www.silver-seal.com they have some specialty stuffLast edited by BOBCRMAN@aol.; 02-07-2005 at 08:12 PM.
Reply With Quote
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
I believe this was somewhere around 2015, Rick, Rosie and Johnboy
John Norton aka johnboy