Welcome to Club Hot Rod!  The premier site for everything to do with Hot Rod, Customs, Low Riders, Rat Rods, and more. 

  •  » Members from all over the US and the world!
  •  » Help from all over the world for your questions
  •  » Build logs for you and all members
  •  » Blogs
  •  » Image Gallery
  •  » Many thousands of members and hundreds of thousands of posts! 

YES! I want to register an account for free right now!  p.s.: For registered members this ad will NOT show

 

Search:

Type: Posts; User: 36 sedan

Search: Search took 0.19 seconds.
  1. Replies
    413
    Views
    61,382

    Been there, done that! LOL! Sold mine....

    Been there, done that! LOL! Sold mine....
  2. Replies
    413
    Views
    61,382

    They think it makes them look smart. If they only...

    They think it makes them look smart. If they only knew it makes them look smart A$$ (emphasis on the A$$). I have a saying for those, "they just can't help themselves!"...
  3. Replies
    413
    Views
    61,382

    I did the drawing as an illustration taken from...

    I did the drawing as an illustration taken from OP's post #150. The drawing is simply to show conflict in movement and geometry, not a guide or anything else. While the usual travel of the...
  4. Replies
    413
    Views
    61,382

    JMHO, ideally you want to minimize any...

    JMHO, ideally you want to minimize any differential to motor angle changes, excessive (or misaligned) angles will eat u joints, bearings and transmission tail shaft bushings. Only trying to help, and...
  5. Replies
    413
    Views
    61,382

    Please check it through its travel (up/down). My...

    Please check it through its travel (up/down). My calcs may be wrong, but it appears your geometry out of sync causing the differential to excessively tilt as it goes through its swing.
  6. Replies
    413
    Views
    61,382

    Please check your 4 bar angle alignment.

    Please check your 4 bar angle alignment.
  7. Replies
    413
    Views
    61,382

    At the risk of controversies I've caused here in...

    At the risk of controversies I've caused here in the past I’ll put my two cents worth in.

    As Jerry has stated, the tie rod ends may not be designed for the loads applied by your application....
Results 1 to 7 of 7
Links monetized by VigLink