Search:

Been there, done that! LOL! Sold mine....

They think it makes them look smart. If they only knew it makes them look smart A$$ (emphasis on the A$$). I have a saying for those, "they just can't help themselves!"...

I did the drawing as an illustration taken from OP's post #150. The drawing is simply to show conflict in movement and geometry, not a guide or anything else. While the usual travel of the...

JMHO, ideally you want to minimize any differential to motor angle changes, excessive (or misaligned) angles will eat u joints, bearings and transmission tail shaft bushings. Only trying to help, and...

Please check it through its travel (up/down). My calcs may be wrong, but it appears your geometry out of sync causing the differential to excessively tilt as it goes through its swing.

Please check your 4 bar angle alignment.

At the risk of controversies I've caused here in the past I’ll put my two cents worth in.

As Jerry has stated, the tie rod ends may not be designed for the loads applied by your application....