Search:
Type: Posts; User: Geezer2
-
09-05-2010 05:46 AM
Thread: How much compression?
by Geezer2- Replies
- 8
- Views
- 5,238
I set total timing only and it's at 36 degrees....
I set total timing only and it's at 36 degrees. 14-16 inches at idle.
Good luck with your build.:) -
09-04-2010 10:15 AM
Thread: How much compression?
by Geezer2- Replies
- 8
- Views
- 5,238
It's a +.030 454 based on an 85 4 bolt block. ...
It's a +.030 454 based on an 85 4 bolt block.
Scat steel crank and I beam rods with K-B pistons. I used a Comp Cams hydraulic roller with Lunati roller lifters, and stainless roller rockers. Cam... -
09-03-2010 02:15 PM
Thread: How much compression?
by Geezer2- Replies
- 8
- Views
- 5,238
You can be street friendly, but will probably...
You can be street friendly, but will probably require 93 Octane and watch the total advance.
Aluminum heads would allow 10.5-1, but with iron heads I would go no higher than 9.5:D -
09-03-2010 08:14 AM
Thread: How much compression?
by Geezer2- Replies
- 8
- Views
- 5,238
The 10CC pistons should give about 8.8-1...
The 10CC pistons should give about 8.8-1 compression with a 118cc chamber.
That compression will be 89 octane friendly and make decent power.
My +.030 BB made 542HP with 9-1 compression and...
Hey Paul got your private message. I typed out quite a long note but the private messaging is limited in words so I left my cell phone number for you to contact me. Most of the American Graffiti...
Cali Road Trip