Printable View
all i get from some of the suppliers is check with hemmings,, who has 41 pontiac front floors, i talked with ems(i think) they said chevy wont work, as the mounting holes will not line up... any help,, much needed, floors, rockers,, etc,, jc
getting ready to chop the 41
http://new.photos.yahoo.com/jefferyc...60762387419034
i'm looking into a company: direct sheet metal
just fab out your own floor, its not too tough, i've done a couple, the only hard part is getting the tranny hump right if you have a console....... if you're good with metal then just cut the old one out and build your new one as close as can be, make your own holes for the seat hardware and such and voila! that or if the chevy one fits just doesn't have the right holes then plug em and put the right holes in it
i would have to think you could adapt '41 chevy floors. Chevs of the 40's or EMT should carry that
i called,, no go,, i will have to fab them out,, i have the rollers, etc, to put some nice curves in them,, thanks to all,,