Heads And Cam Combo 280h Comp Cam Sbc

Printable View

11-26-2007, 10:06 AM
BigTruckDriver

Heads And Cam Combo 280h Comp Cam Sbc-041 and others

I have a set of 65cc iron heads (bought from Indy cylinder head)with screw in studs and guide plates for sale, they have also been gasket matched for a felpro 1205 intake gasket. They will need resurface but should be fine at 64cc. I also have a set of 58cc 041 iron heads that have been ported and polished and gasket matched to the felpro 1205 intake gasket. Both sets have screw in studs and guide plates. I will sell the heads assembled and ready for bolt on. All parts are new except for valves. Springs are new ,retainers,locks, arp studs guide plates. Heads have been set up and ran with a 280h comp cam package/kit. The assembly only seen about 1000 miles ,if that. I also ran at the track 1 time. If needed I can show pics of the wear pattern on the vavle stem tip, almost cant be seen. I also have a set of Crane roller rockers that were used with this set up, 1.5 ratio. I can sell either heads with the 280H combo ,everything includeing timing chain to the roller rockers. All you will need is lifters and push rods.

I have new springs and retainers also that came with the Indy heads that can be installed on either of the heads I will get specs on those and pics.
11-26-2007, 12:21 PM
gassersrule_196

how much for the cam, and how much for the 041's?
11-26-2007, 03:19 PM
BigTruckDriver

All set up or just the cam and bare heads? I mean are you looking to use the timing chain ,springs, locks ,retainers and cam ,which are all comp cam parts. I had bought the complete kit. I can piece it out also.
11-30-2007, 01:47 PM
BigTruckDriver

5 Attachment(s)

In case any one else is interested here are some pics. I would rather sell the heads assembled and complete ready to bolt on. I will get heads cleaned and inspected so there is no confusion on what you are getting ,even though all hardware is new ecxept for the valves.
01-24-2008, 05:35 PM
brickman

I would like to know what your looking for on the heads.
01-24-2008, 06:48 PM
BigTruckDriver

If you asking about the 041 heads , 500 and I will pay for shipping. This would be for assembled heads all cleaned up ready to install up to450 "stock" Z-28 springs good to 450 lift and comp cams spring kit good to 480 lift ( 041's cut to bigger diameter springs).