Chevy SB

[Bob W]

For Sale:

1 Crane H-284 Camshaft and Lifters, 1 Edelbrock Performer Intake.

Bob
willisb@kos.net

[brickman]

Is that a hydraulic lifter cam? How big is the cam, stall converter needed? Used or new?

[Bob W]

Hyd Cam 284 Duration and 450 lift. Slightly used cam and lifters. Specs below from Crane Cam site.

Bob

Part Number: 114201 Grind Number: H-284 (REPLACES CCH-284)
Engine Identification:
Start Yr. End Yr. Make Cyl Description
1957 1987 CHEVROLET 8 FAIR IDLE, MODERATE PERFORMANCE USAGE, GOOD MID RANGE HP, MILD BRACKET RACING, 3200-3600 CRUISE RPM, 9.5 TO 10.75 COMPRESSION RATIO ADVISED. (50 STATE LEGAL PRE-COMPUTER, C.A.R.B. E.O D-225-21) BASIC RPM 2200-5200
Engine Size Configuration
262-400 C.I. V

Valve Setting: Intake .000 Exhaust .000 HOT

Lift: Intake @Cam 3001 @Valve 450 All Lifts are based
on zero lash and theoretical rocker arm ratios.
Exhaust @ Cam 3001 @Valve 450
Rocker Arm Ratio 1.5

Cam Timing: TAPPET @.004
Lift: Opens Closes ADV Duration
Intake 27 BTDC 77 ABDC 284 °
Exhaust 75 BBDC 29 ATDC 284 °

Spring Requirements: Triple Dual Outer Inner
Part Number 99848
Loads Closed 114 LBS @ 1.700 or 1 45/64
Open 303 LBS @ 1.270
Recommended RPM range with matching components
Minimum RPM 2000
Maximum RPM 6000
Valve Float 6600

Cam Timing: TAPPET @.050
Lift: Opens Closes Max Lift Duration
Intake 2 BTDC 40 ABDC 109 222 °
Exhaust 50 BBDC (8) BTDC 119 222 °

[brickman]

Thanks Bob, turns out to be just a little bigger than the one I have now. I was thinking of going bigger, thank you for the information.