Threaded View
-
07-18-2004 07:06 PM #11
Appreciate it, Spray.
My first paint job was with a PPG single stage, so I am a little familiar with their products. That sounds like a good way to go.
Some information I have read suggets that you should apply the minimum amount to cover because the thicker the stripe the more of a ridge there will be on the finished stripe edges. That makes sense, but is that the best way to do it?
Would I need to leave the tape on until the paint has fully cured?
What grit of paper do I need to use to scuff the factory surface where the stripe will be painted?Andy
My project build video:
http://www.youtube.com/watch?v=iubRRojY9qM
My wife told me the kitten needs to be chipped. I had only a 9 iron but I still got it over the shed.
the Official CHR joke page duel