Printable View
i want to clean up the frame and paint it. it still has the body on but motor and tranny are out. the frame rails are covered in nasty gunk. what i would i use to first clean up the frame, then how would i paint the frame with the body on it and which paints and primers should i use. What steps would i use also? Thanks,
Vince
Streets man ive read a lot of posts with your comments in it and you always got smart a$$ things to say. all i want to know is how do i clean up my sub frame and paint it with the body on still and if you can't help then i would appreciate it if you didnt reply. thanks,
Vince
I would use a steam cleaner or at least a high power pressure washer with some good de-greaser... This process will also strip off any old paint as well...
As far as painting goes, I would recommend an epoxy primer before you start to paint...
Hope that helps...
Dave Brisco
He ain't the trool, YOU ARE CSF. Streets is one of the most knowladgble people on this site.
age isn't everything CSF, I'm 29 and can wrench circles around most people. It's because I was taught by the REAL Hot rodders who were around "back in the day", before all this gold-card catalog pansy billet wussy hot rod crowd existed.
We build our rods the old fashioned way, make our own parts, do our own engine, trans, fram, suspension, leadwork,etc...
And as I always say...
speak softly, AND CARRY A BIG TORQUE WRENCH! :LOL:
are you in the city ? if not push it out side and call a mobile sandblaster, plastic cover the car body and wshield very good . that will clean it to bare steel , then a self etch primer, then a good quality high build primer , sand and spray . that is the correct steps .as far a type of paint try to use a urethane .
i dont thin you can buy imron and if you get it , it will chip easy .
plus it stinks like hell.
hope this helps
kenny
Without a whole lot more work, you could unbolt and dissassemble the subframe, have it sandblasted, clean up the welds, repalace all the worn busings and joints, paint it and put it back together. I know, easy to say when I'm not the one doing the work or spending the $$$ on parts. It does make for a very first rate looking job.
Thanks for all of your opinions and options you have left me with to try out and i will let you know the outcome. I just might unbolt the subframe but who knows. Thanks again