Well last weekend I started the bodywork. It was a rough time too! I am just working panel by panel, so I started with the right front fender. I stripped it down to the metal with some 36 grit and smoothed it out with some 120-150 grit. Then I banged out as many dents as I could that someone previously just filled..:rolleyes: Then I used some Evercoat Rage and filled the low spots. Then after sanding everything smooth and priming it with some Epoxy, I could still see the low spots...:mad: So WTF did I do wrong??? Here are some pics to give you a better idea:
Down to the metal:
http://img.photobucket.com/albums/v4...03/body001.jpg
Primed Up (dosen't look near this good in person, lol):
http://img.photobucket.com/albums/v4...03/body005.jpg
Now a better angle to see the lows:
http://img.photobucket.com/albums/v4...03/body012.jpg
Also, the outter sheet was rusted, so I cut it back and grinded everything smooth. Then I filled and leveled it with the Rage. Is this ok or not?? Here is a pic of the area preped:
http://img.photobucket.com/albums/v4...03/body002.jpg