Hybrid View
-
09-25-2006 08:12 PM #1
dodge 360 piston skirt clearance
When I checked the piston clearance It said i had .011 of claerance I checked this on tdc on the top part of the piston using feeler gauge. Is that the right way to do this? If it is, I think I have way to much clearance.
-
09-25-2006 08:59 PM #2
no, you have to get the feeler gauge down past the rings, 90 degrees from the axis of the wrist pin.PLANET EARTH, INSANE ASYLUM FOR THE UNIVERSE.
-
09-26-2006 05:58 PM #3
When I checked it at the skirt it said I had .002 clearance. Is that to much?
-
09-26-2006 06:51 PM #4
it would have to do with the pistons are cast hyper or forged if cast they are fine i put new cast pistons in at 001.5 on a new bore for stock use and run them bigger if run hard and hot so you should be fine
The main function of your little toe is to make sure all the furniture in the house is in the right place.
the Official CHR joke page duel