Anyone have a plan for a 32 Ford frame jig, or know where they sell them? I am tossing around rebuilding my 32 frame myself. It would be a very first for me. I would buy a TIG welder, establish a jig somehow and just go slow. I need to deturmine ride heighth, and take a million measurements, and then start cutting out all of the old cross members. I want to box the frame and install a new C.E. X-Member. I don't even have 220 service in the garage yet. I got a 27 T Tudor Sedan on a 32 frame. Suicide front end and I want to install a quick change rear. The frame is twisted from someone installing a transmission cross member in the late 60's and they didn't take the weight off of the frame(motor and trans were in) and it bowed. I know it will cost me alot more to do it myself, but that's kinda what hot rodding is all about. Popping the clutch for the first time and hoping your welds penetrated correctly and the frame is square. I have not fully decided to do this all myself yet, it's just an idea. I would have to run 220 service, build or buy a frame jig, and buy a TIG welder. Any thoughts? There is no time limit, so if I obtain my own jig, I can take as long as I need.

Please Help with suggestions/experiences!!!
Thanks
Rich DeBene
313 563 2072