The driver fender has issues as well. It was hit pretty hard at some point in it's life and the is about an 1/8th inch of bondo in the middle of the fender and down into the lower part. I found all of this while unbolting the inner. Ran a flap disc over the "fixed" area to show the high and low spots.
https://media.fotki.com/2v2EdcFSNx9EDKg.jpg
https://media.fotki.com/2v2Edw2ULx9EDKg.jpg
Also opened up the "bubbles" in the rear roof corners. I knew this was there, now I have to figure out how far I want to go to fix it.
https://media.fotki.com/2v2EdcFbFx9EDKg.jpg
https://media.fotki.com/2v2EdcFQqx9EDKg.jpg
There was also some delamination along the top of the pass rear quarter. I took this down to bare metal as well and found nothing bad.
https://media.fotki.com/2v2EdcF75x9EDKg.jpg
The delamination was due to shoddy prep work, which is fine, this is an easy fix. :)
Mark