Zack is here

Zack is a welder - fabricator who was laid off a week ago . So he offered his talents out at a very affordable rate . Well having so much work I called on him to help with the 31 to get it to sell . He is in my book a master sheet metal guy who as a builder himself does fantastic work . Glad he is a local and and a god send for these old tins .

Hope he goes back to work soon but until then he has some work here with me . He has done a tremendous job on saving a fender I thought was gone for my skill level anyway . Well I am sure there is alot that can save it but not at his rate right now .

This is just one of the bad fender out of two with this type of damage .

Click on pic and use the zoom for close up .

http://inlinethumb25.webshots.com/45...425x425Q85.jpg

http://inlinethumb40.webshots.com/41...425x425Q85.jpg

made it look almost new. great job.

Yes girl he is a talented metal man . Slight skim coat and cover wit primer .

nice to have talented friends!

Stove I found a Dave nearby . He is doing all the hammer dolly on the A . He will have it finished today so a skim coat of plastic can be applied .

Teaser pic to get more of us going on the car . This guy did some tremendous work in 19 hours . Even though I am putting this one up again soon it will start and stop as you do a short run in the neighbor hood .

http://inlinethumb40.webshots.com/44...500x500Q85.jpg