Hybrid View
-
05-25-2009 07:08 PM #1
? about installing pvc in vintage cal custom bbc vavle covers
for you guys that have or know bbc cal custom vavle cover, I am wanting to remove the "cal custom" logo to install a pvc valve. I know it can be removed... does it need to be drilled out or just punched out?
thanks
-
05-25-2009 07:26 PM #2
Had a set that looked like a knockout, but I drilled them just to stay on the safe side.theres no foo like an old foo
-
05-25-2009 07:30 PM #3
yuppers, drilling is usually a lot more accurate then a hammer.....Yesterday is history, tomorrow is a mystery, Live for Today!
Carroll Shelby
Learning must be difficult for those who already know it all!!!!
-
05-25-2009 10:20 PM #4
I thought that the "cal custom" logo is just press fit into place, if it is, I would rather ude a round wood dowel & hammer to knock it out, incase I every want to put it back in. but if drilling it out is how they intended you to remove it I will go that route. I was hoping that someone here, has done it, & could tell be for a fact how is the best way to remove it.
-
05-26-2009 05:46 AM #5
All of the Cal Custom covers I've had, big or small block, the "plug" was cast right along with the rest of the cover. Always had to be milled or drilled, never seen one that was a press in plug.Your Uncle Bob, Senior Geezer Curmudgeon
It's much easier to promise someone a "free" ride on the wagon than to urge them to pull it.
Luck occurs when preparation and opportunity converge.
On a bitterly cold winter morning a husband and wife were listening to the radio during breakfast. They heard the announcer say, "We are going to have 8 to 10 inches of snow today. You must park...
the Official CHR joke page duel