I looked into how they are made, went under my car and found I have no room only 18 inches from the end of the sub frame to the wheel well and it curves with the suspension anchor and hand brake cable being in the way. I looked ahead of this and was wondering if I connect a beam across the two ends of the sub frame and used the middle as a tail shaft loop with exhaust cutouts would this work, it would place the connectors half way between the gearbox X-member and the the end of the sub frame, I could use a K style to then connect it to the floor of my car and have both ends in the sub frame, does anyone have any ideas on this, I searched google Australia and could not find anyone who had made a set for my 1971-74 HQ Kingswood and Monaro. Hope you blokes like an engineering challenge.

Cheers Albert.