Thread: Mickey Thompson Tires

Tweet

I have a 70 Camaro tubbed with MT and the same thing happened to me....... NOW just last week i found that my rearend was bent sooooooo i will not have the new rearend untill next wed or so i hope that my wobble is gone........I hope your problem is not the same as mine becaue mine was a $2400.00 fix.

Sid

I just don't know how i bent my rearend??????????

Thanks For The Reply Henry, I Am Running 20 Lbs Air Pressure. Don't
Know Exactly What I Am Suppose To Run, Do You?
Hey 1badmofo, Nice Looking Car You Have There, I Was Going To
Ask About Your Bent Rear End, My Guess Would Be You Have Alot
Of Hp And Torque That Did It.
Rdobbs

Hey 1badmofo, I Meant To Ask. How Did You Come About Knowing
Your Rear End Was Bent?
Rdobbs

I was changing the gears and the pass side axle would not come out, after some time it come out and that was not enough for me to look sooooooo i went ahead and set up the gears when i was putting the axles back in that side they would not go all the way in so i grabbed the other axle and tried to put it in and it would not go in so i took both axles to the other side and they both went in great so i took the rearend out of the car and sat in on the floor and you could see bend very easy........ the pass side was towed in about 1/4 th 3/8 of a inch.............for the last 18 yrs i have been running a Chevy 10 bolt with 35 spline axles and a spool I am replacing it with a ford 9 in 35 spline and spool.


The short answer one axle would come out easy and it WOULD NOT go back in.

Sid