I just found myself under the cab of the truck grindin humps down and gettin ready to start fillin spot welds when I realized ,who in the world is ever gunna see it ?This is not a show truck and I am going to drive it daily even do a few burnouts and sling gravel all over the bottom!!!When is enuff enuff ,what do u let slide and what do u keep workin till its perfect ?I have the doors painted on the top for the 2 tone and I find myself holdin the door up to the light and lookin from all angles like a jewler lookin at a diamond!!!! If u hold it upside down and at a 32 degree angle and look just like this ........... u get my point.Am I always gunna see a flaw here and there because I am the builder?And if so how do u rationalize it away? I feel like even though no one else will see I will know. Scenario (" hey thats a nice ride and those doors look sharp!"!)thanx !!!but inside my head sayes (yeah but theres a flaw inside the door and I coulda bought new linkage for it all !!) or is that why most builders end up sellin ,because u know about spot weld 400 u did not float out the best? Just tryin to get a head of steam up and push thru with this project and dont want any baggage eatin at my progress.I guess I just need to goto a couple of car shows and go look at the nicest rides and pick some flaws out so I will feel better!!!!!!