This is going to be the "new and improved" welding/grinding bench! It had been sitting by the side of the road for a few days before I couldn't take the pressure and had to pick it up... Poor old girl...

I had already removed the two end drawers and dummy front in that pic.
I dug into my wood pile and hauled out some 1 x 3"s, a couple of short 2 x 4's and some 1 x4's I salvaged from a shipping container.
Here are the drawers (and one I had in my stash) that will be going into the bench when it's done.

reinforcing the bottom with a couple of 1 x 3's and adding 2 x 4's for a place to mount the CASTERS!!!!

Added some stretchers to the top to stiffen it up and have a place to bolt the OSB top down. Do you see the HF furniture dollies on top? Yea...

I blew one of the dollies apart and bolted/lagged the long sides of the dolly to the ends of the bench. The casters bolt right thru the bottom plate into the structure I added. Sturdy..

I will be adding some structure to the end caps also. Either a sheet of OSB screwed from the inside or just a 1 x 4 verticle cap on each corner. I'll probably do the OSB, it will give me some thing to screw to when I add tool holders to the ends of bench. This will get an OSB top tomorrow and eventually a 3/8th X 24 X 52 inch piece of steel to finish it off... And, of course, an electrical outlet and long extension cord I MAY even paint it!
I have a grand total of 8 dollars into this as it sits tonight... That was what I paid for the dolly...
Thanks for looking.
Mark