Happy Easter Everyone----. I have been playing hard with my new toy, doing all the simple set-ups for facing, center drilling, parallel turning, etcetera. I broke the bank and bought everything necessary for me to do milling in the lathe as well---the picture is of a very simple milling set up. I am "milling" a block of wood in the picture, because my fancy lathe stand with cabinet and drip tray are on back order, and I can't use any coolant or it just drips all over the floor right now. (The lathe is currently set up in my office). The equipment for milling in the lathe basically consists of a "worktable with Tee slots" which bolts onto the cross slide where the top-slide normally sets, an angle block, and a two way vice that gives that much needed third axis of movement for milling a part. I don't anticipate doing a lot of milling anyways, but its nice to have the equipment if I want to.