The driver side body mount is done! And, I made some improvements over the factory design, this time it is completely boxed in, no where for the muck to add accumulate and rot it out.

It really looks clean and pretty in stainless. It makes me wonder why more don't do it in stainless? Sure it's heavier but unless you are replacing a floor I can't see weight as a factor. It is a bit harder to fabricate, true. And if you're paying for it, more expensive, but this scrap was free.
It's easier to weld by far.

Anyway, what do y'all say?

Also, anyone want to post some pixels for me?