Haven't been on in a while. With summer time here, and my daughter finally being old enough to somewhat re-establish the lives we had before she joined us, the family and I have been doing a lot of camping, hiking and fishing. That, and its just been too dang hot in my shop to get anything accomplished. I mustered up some motivation and decided to get up early this morning and get something done on the sedan, before the sun made it past the evergreens onto the shop.

Decided it was time to tie up the loose ends and finished the passenger side rocker and rear wheel well arch. I started by making the bottom cap. Took some figuring, and I was a bit rusty, but I got it worked out.

IMG_20180728_105705317 by Ryan Mazingo, on Flickr

IMG_20180728_105700275 by Ryan Mazingo, on Flickr

Didn't end up using much of it, but I made it not knowing how much I wanted to replace. Some of my previous work I had been questioning, but I decided it was better than I had remembered and left it.

IMG_20180728_115517289_LL by Ryan Mazingo, on Flickr

Got her all welded in and finished out the rocker once it was in. I didn't bother filling the inner wheel well, since I know already I'm going to have to do some operating in there after I narrow the rear frame rails; that's a whole other basket of worms I'll be covering later.

IMG_20180728_131757966_LL by Ryan Mazingo, on Flickr