Excellent!
Excellent!
That is turning out very nice!
Thanks, I am very happy with it. It is mostly done as is the remote latch
https://lh3.googleusercontent.com/-f...510_123215.jpg
https://lh3.googleusercontent.com/-r...510_123343.jpg
https://lh3.googleusercontent.com/-W...510_123453.jpg
http://www.BenModified.com
Started building the passenger side scoop today
https://lh3.googleusercontent.com/-K...415_132938.jpg
https://lh3.googleusercontent.com/-K...511_174236.jpg
http://www.BenModified.com
Killer way to do it! I really like that!
Finished up the passenger side scoop
https://lh3.googleusercontent.com/-8...518_121157.jpg
https://lh3.googleusercontent.com/-L...518_141905.jpg
And got started on filling the gap under the doors.
https://lh3.googleusercontent.com/-A...518_153605.jpg
https://lh3.googleusercontent.com/-w...518_153620.jpg
https://lh3.googleusercontent.com/-m...518_161024.jpg
https://lh3.googleusercontent.com/-7...518_161528.jpg
http://www.BenModified.com
Part 14 of the Build is on YouTube
https://www.youtube.com/watch?v=shN-Qcv2xvI
I spent some time yesterday applying a little body filler on the rear fenders. Today I sprayed them and the bed tubing with some rustoleum prof grade bed liner. I like the way it turned out.
https://lh3.googleusercontent.com/-y...521_181917.jpg
https://lh3.googleusercontent.com/-Y...521_181922.jpg
http://www.BenModified.com
I like it too!
Closed up the gap under both doors. Some light sanding still to come.
https://lh3.googleusercontent.com/-M...523_151847.jpg
https://lh3.googleusercontent.com/-O...524_165926.jpg
Also posted Part 16 on Youtube
https://www.youtube.com/watch?v=JIeS9brt95g
Apparently Block Hugger headers and urethane engine mounts do not play well together!
https://lh3.googleusercontent.com/-9...611_123639.jpg
https://lh3.googleusercontent.com/-X...611_123538.jpg
https://lh3.googleusercontent.com/-o...614_150249.jpg
Wrapped the headers where they immediately surround the motor mounts. If the mounts do not melt any further, then I will install new ones.
https://lh3.googleusercontent.com/-a...615_124731.jpg
Also boxed in the area between the front of the radiator and the back of the side air scoop to keep hot engine compartment air away from the front of the radiator.
https://lh3.googleusercontent.com/-n...615_124803.jpg
https://lh3.googleusercontent.com/-d...615_124810.jpg
http://www.BenModified.com
Nice work! That stinks about the mounts. Hopefully that wrap will eliminate the melting for you. The fenders look great!
I don't think I've seen a mount do that before. Perhaps when you do replace them, you might add in a simple metal heat deflector, to shield the mount.
It could mount under the same fasteners as the mount??