Ran shroud-less for a number of years, as you know HotRodding is a progressive hobby with lots of round 2 its. This waited the longest, going to knock it out and be done with it.
So here goes first pictures: layout
Printable View
Ran shroud-less for a number of years, as you know HotRodding is a progressive hobby with lots of round 2 its. This waited the longest, going to knock it out and be done with it.
So here goes first pictures: layout
Looking forward to the build pics - - - FWIW, I have a box full of "round 2 its" but I've misplaced them.
meller
Basic shape done, best way to make the fan cutout was to use a nibbler. Zero distortion, very fast and surprisingly easy to do the circle. Drove it right around the line nice and clean, would not have believed it if I had not seen it..
Now in one piece I will cut it in half with the bandsaw, it will install in halves.
Attachment 62627
Attachment 62626
Looks like both brains were working for you during construction! NICE!
Did some fitting and building after work. Making the reliefs for the upper and lower radiator hoses. Getting close to having all the parts made.
Attachment 62639
Attachment 62640
Gonna be good.. You're making it look easy.. LOL.
Nice job you are inspiring me to give it a try!
Real nice lookin' piece Pepi, kudos to you.
.
All the parts are made, now painted, and hanging for a few days. Aluminum is the color, the vertical sides will have thin black door trim to seal and isolate the shroud from the radiator. Top part rest up & under the lip of the tank.
Did a smoke test for air flow for a base line before I started the build. The only draw I was getting was from the lower left quarter. Have a trans cooler directly centered on the face, with a 2 - 3 inch gap top to bottom that canters back following the grill angle. Never had any real serious temp problems, but did get some big swings 20 - 30 degrees. Hot day in traffic 200 but would settle back down to 180 when rolling.
Attachment 62658
Attachment 62657
Great work Pepi, should help immensely with the cooling!
Nice work! I always wondered how guys were getting those big circles cut in sheet metal by hand and to have it look perfect.
Installed the shroud, fired the motor. No smoke test needed, can feel the air flow draw all thru the radiator surface a big improvement. Even feel the air at the face of the firewall.
Naturally had to road test, the temp is now very stable. No big swings. With the weather cooler the climb from cold to running is smooth. Comes to temp and just hangs right there... this was a good project and turned out very well.
The car likes it !
Attachment 62687
Attachment 62685
Attachment 62684
Attachment 62686
AJWD, Pepi
"a well made shroud"
"should make you proud"
Looks great. How did you attach it to the radiator?
looks great