-
-
Like the looks a lot better without the bumper, but now how are you going to tow anything?:whacked:;):LOL:
Jack.
-
Haha wasn't planning on towing anything, I actually have the original rear bumper and 2 out of the 4 original brackets as well
-
Wow, that was a whole lot of rear bumper!!!! Lots of old trucks had similar overweight behemoths like that, could pull a house with them!!! Now a good receiver hitch works just fine. Anyway, looks like you have the start of a good scrap iron collection with the old bumper!!!!!
-
The bumper may have made wheel stands easier , and if it hit the asphalt no problem :D
.
-
1 Attachment(s)
Hi Eddie, I just discovered this thread and will be following along now. I have an interest in your project because I started to build one similar to it once, but sold it before it was finished.:( Mine was a '51 and began life as a 3/4-ton. It was 100% original when I got it, but the flathead engine was frozen and the rear end was locked up from sitting in the weather for too long. Fortunately, the body was really solid. I grafted on a '76 Camaro subframe up front and re-contoured the rear frame. I put a 9-inch rear from a T-bird under the rear on coil springs and ladder bars. All together I lowered it 8 inches. I had all the hard work done and the body roughed out except for the bed sides and tailgate when I was forced to move it. I didn't have room for it in my garage at home and I didn't want to leave it sitting in the weather again, so I sold it. I have regretted it many times since.:CRY: Moral of the story - hang on to that jewel! Here's a pic of mine just before I sold it ten years ago.
-
Looking real good, Eddie!