Thread: 302 Laying down
Threaded View
-
01-02-2005 07:22 AM #1
302 Laying down
Help!
I have a 302 bored .060 over.
Mild cam
Edelbrock intake
Edelbrock 650 CFM 4 barrel carb
Headers
MSD 6ALN box
Automatic
79 F100
Was getting on the highway and had it to the floor, went through all the gears fine, when I reached about 65 it was like someone turned the switch off. It came back, pulled a little bit and did it again. I let off the throttle a little and then floored it again, same thing. If I am not all the way into the carb the engine pulls fine, seems that the problem is only when I am in WOT.
If I shift to first and floor from a dead stop it it pulls like crazy all the way up till the MSD kicks in and starts dropping cylinders like it is suppose to.
What is causing this???????
Another question, I was told this engine takes 6 quarts of oil. Is that correct? It's a remanufactured 350 with stock pan.
SB distributor won't fit