Thread: 460 Panther Marinetec motor
Threaded View
-
05-15-2006 11:38 PM #16
so the cam hit the counterweight no they hit on if any on the side of the rods the case of the block will hit before the counterweight would hit the cam. swhanlee28 thanks for the nice comments and my tools have work on fords .i have a customer that hase a pull truck that eats 520+ fords and it a 496 kane needs to get up to speed on the chevys i am not saying you can not make fords run BUT if you think you are going to just run one over a chevy and i have no need to get up to speed on the fords i have work on them and valid technical info swhanlee28 you may want to look at my 1600 +post and read back thru some of them on big block chevys? . 600 hp can be done with stock gm big block stock stuff .new ford info?? i can not keep up with all the new chevys heads that have came out in the last two years so do you think the chevy info i know is old news?? why yes it may be 1965 is when they came out but i have built many over 540+ big block chevys and they had 750to 800 lift cams .oh they look better to. swhanlee28 are you selling your chevy truck?and if it was not for the cheap H beams bbc chevy rods you use and the rod bearings you could not cut down your cranks and do it on the cheap?Last edited by pat mccarthy; 05-23-2006 at 03:42 PM.
Awesome, I will put 5 quarts in when the time comes. I've always used Valvoline, what viscosity would be recommended for So.Cal.?, and thanks again
SB distributor won't fit