Thread: Rocker Geometry Tool
Hybrid View
-
04-05-2016 11:51 AM #1
Rocker Geometry Tool
Has anyone used this rocker geometry tool made by Proform? Thanks,
Proform Pushrod Length Checkers 66790 - Free Shipping on Orders Over $99 at Summit Racing1972 Z28 Camaro, Full Drag Car, 383 CID
1976 Camaro
Currently building a 1.21 Gigawatt Flux Capacitor
-
04-05-2016 12:51 PM #2
Suggest you use the procedure outlined by Straub Technologies in this video......
https://www.youtube.com/watch?v=o5is9BsH5OU
.PLANET EARTH, INSANE ASYLUM FOR THE UNIVERSE.
-
04-05-2016 04:02 PM #3
Hey Tech, I've watched that video a few times. Don't know if I did something wrong last Saturday but: I know to take my gross valve lift, divide it in half, take the 3/8 stud measurement of .042 and divide that by half the valve lift. That comes to around about 5.5 turns on the 355's rocker after I've drawn a centerline thru the rocker and lined it up with a key stock, ruler, etc. Here was the problem I found. I could put the rocker on and barely turn the nut to keep the rocker on there (forget about the center line of rocker for a minute). After that, there's not enough thread there to even allow for 5 turns. That's why i was curious about some other methods out there or tools. Thanks, Bobby1972 Z28 Camaro, Full Drag Car, 383 CID
1976 Camaro
Currently building a 1.21 Gigawatt Flux Capacitor
The main function of your little toe is to make sure all the furniture in the house is in the right place.
the Official CHR joke page duel