Thread: Mallory E-spark conversion kit

Tweet

Get a Dodge pickup and a reluctor. Machine the reluctor to press fit over the points cam. Press fit it on with some loctite. Install the Dodge pickup where the points were (will have to re-drill dist plate). Find a cheap heat sink from Radio Shack and install a Chev 4 pin ignition module on it. Wire it all in. There you have an Electronic Ignition setup for a Chev points type dist. All the parts can be found at NAPA.

Or you could get Bubba to do it for you.
Bubba's

Contact Dave Ray. He posts on other boards under the name of Ignition Man, and he will rebuild your points distributor into an electronic distributor. I have heard very good reports about his stuff. Contact him at sparkman451@earthlink.net