Hi everyone. Some of you may remember i posted a thread a while back concerning my distributor suddenly going 55 degrees out. Well, i feel like a dumb ass cause i took it out of the box again yesterday and it turns out the problem WAS something moving internally! The part that the rotor fastens to is moving on the shaft. I figure a couple small spot welds will fix the problem but here's my question:

Does the magnetic pickup need to be aligned with the rotor in any way? It seems to me that the rotor tip should line up with one of the 'blades' on the mag pick up...

Ok, hopefully this all makes sense.. Thanks very much for any help!

-KD

ps: Btw, it's an accell street billet distributor vac/mech advance p/n 52100