Hybrid View
-
10-01-2006 04:45 AM #1
elde 600
i was told to make sure im on the idle curcit when i adjust my carb how can i tell is there a certain rpmGLENN
you can do it if you know how it works
-
10-01-2006 10:32 AM #2
There are two idle mixture screws on your carb. ( On the front of the carb, not the screw on the linkage arm that sets your idle speed) Turning them in leans out the mixture, and out makes it richer. If your car (all warmed up) is at idle, and you turn either one or both screws in, and it stalls out, then you're on the idle circuit. If the screws have no affect on the idle, then you're not idling on the idle circuit. If that's the case, get back in here and let us know what's happening.When your dreams turn to dust, Vacuum!
-
10-01-2006 04:10 PM #3
no it stalls out and then i adjusted them with a vacuum gauge againGLENN
you can do it if you know how it works
-
10-02-2006 01:49 PM #4
Then you're on the idle circuit. Do you adjust for max. vacuum by going back and forth between the two screws? That's basically how it's done. Are you having a problem in particular, or just wondering? JohnWhen your dreams turn to dust, Vacuum!
-
10-02-2006 05:19 PM #5
no problem, just in stalled a bigger cam and wanted to make sure i was getting the max idle mixture adjustment. after i get the highest reading on the vac. gauge then i turn them a quarter backGLENN
you can do it if you know how it works
-
10-05-2006 01:54 PM #6
I would say no on the highest vaccum method. If you used the lean drop method: you adjust for highest idle speed than drop 20 rpm on each screw. The screws do not need to be the same in or out.If it's not broke, fix it anyway.
Awesome, I will put 5 quarts in when the time comes. I've always used Valvoline, what viscosity would be recommended for So.Cal.?, and thanks again
SB distributor won't fit