Thread: need help with efi 5.0
-
07-11-2004 05:58 PM #1
need help with efi 5.0
I am putting a efi 5.0 out of a 1987 LSC MARK VII in to a 35 FORD 5 window and i need some help with all of the efi, what i need and what i don't need or if they are any literature to help me figure it out. thanks raceingraceman
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
07-14-2004 05:34 AM #2
some help
you need to look at the vacumm and wiring diagrams for the make and model of the original vehicle 5.0 was in
wiring dia grams will help with what you need and what you don't
use your best judjement on things you need and dont need
you need all the wiring from the eec/iv module the box on the driver side in the passenger compartment
if you need to know more post itLast edited by chevy-ford_man; 07-14-2004 at 11:47 AM.
-
08-02-2004 04:35 PM #3
tank fuel pump (45 PSI) / MAP sensor from firewall (ford one uses frequncy not voltage) / and all the other sensors (intake temp / water temp NTC) etc ....
here's the latest, I had to cut up the cross section of the frame to get the parallel bars in place and these pic's show my fix . 3 x 6 tube used to rebuild the frame section. [/URL] after lots...
New Project