Thread: Need help with ignition timing
Threaded View
-
08-04-2012 09:11 AM #1
Need help with ignition timing
The degree markings on my Chevy 350 Small Block engine are all scratched off.
I can't tell where the timing is on a new motor i bought.
It wouldn't start when i put it in the car so i found top dead center and that still didn't work. I flipped the distributer around 180 degrees and the car runs now but will not accelerate. I believe my motor is 180 degrees off but i have no markings to figure out where to go.
How do i time this motor COMPLETELY from scratch?
This is my first motor swap and I'm really stuck so i appreciate any help anyone can give me. Thanks!
The Australians have finally discovered the origin of the word 'Vegan.' Apparently it's an old Aboriginal word for 'Bad Hunter.'
the Official CHR joke page duel