Thread: 302 cyl head print (needed!)
Hybrid View
-
11-10-2010 03:28 PM #1
I think he is talking about the relation ship of the mounting bolts to the 1.9" dim.. They are not centered to the port. The ball pein and poster board is a good idea. Henderlong are you going to program a digital pattern into a water jet or laser?
-
11-10-2010 04:40 PM #2
Yeah, sfort I agree. I would put a bolt in the front & rear mounting holes on the head, run a good straight edge across the top & bottom of the bolt measuring to the respective port edges. Those measurements plus the bolt OD, all measured with a dial caliper will give him the offset within 0.001" or closer. I'd rather have the measurements from my head than the dimension from somebody's drawing.Roger
Enjoy the little things in life, and you may look back one day and realize that they were really the BIG things.
On a bitterly cold winter morning a husband and wife were listening to the radio during breakfast. They heard the announcer say, "We are going to have 8 to 10 inches of snow today. You must park...
the Official CHR joke page duel