help with head gaskets

[tyler]

i went to the store yesterday and looked for head gaskets for my 406. its a pretty rare motor so it wasnt in advance's computer but i found the stock one in felpro's catalog. that one wouldnt work because the bore on it is 4.13 and my bore is 4.19. so i called up felpro and asked if the one they listed in their high performance catalog (which had a bore of 4.40) would work well the guy i talked to didnt seem too sharp and was just like yah it will work and kinda blew me off. i just wanted to make sure that this one will work bc there is a lot of difference between 4.19 and 4.40
thanks guys
tyler

[techinspector1]

Give Cometic a call. They'll make any gasket in any bore for any motor starting at, I think, 0.028" compressed thickness.
http://www.cometic.com/custom.aspx

[FFR428]

Tyler I have a set of original Ford steel shim head gaskets for the 406/428. I was gonna ebay them but if you can use them they are $35. These gaskets are .020 thickness and I believe the bore size is 4.33 but I'll have to measure to be exact. Send me a email or PM if interested. They are to small for the 427's I need.

G.

[FFR428]

Oh and if you need thicker cometic gaskets Vic Reinz sells a set I can email you a list with part numbers for all.

G.

[tyler]

i got it sorted out today with felpro tey got me 428 gaskets. so all is well now i just need to bolt it together well thanks guys for your help