I.m building my blown 392
Now it's time to order the last parts.
The 6-71 that I have will give me @ 5 %
overdrive 11 PSI
I have M/T rods . ARP mains and head studs.
Engine will run on propane ( High octane fuel )
Maby I will start with gasius propane but want to go LPI.
What is best for this engine?
Go for other pully to get around 14 PSI
And what compresion ratio pistons are than adviced.
Or stay with the ( A bit low ) 11 PSI
What is than the max compresion I can use .
Am thinking of O ringing the block ( Good ot bad )
I'm not sure if I want to go 4 bold main.
Trans will be updated to a 4L80
Car is heavy 5600 LBS
Tailor is around 6000 LBS

Thanks for the advice

Remco
The Netherlands