Hybrid View
-
05-18-2015 07:16 AM #1
Iskenderian 201076 cam valve spring recommendation
Hi!
I bought a ISKY 201070 cam and it came without the cam card, so i donīt know what valve spring pressure should i use.
I tryed to email iskenderian 10 times and no answer back.
Someone can help me?
Thank you!
Ric
Cam Style:Mechanical flat tappet
Basic Operating RPM Range:3,500-7,500
Intake Duration at 050 inch Lift:264
Exhaust Duration at 050 inch Lift:264
Duration at 050 inch Lift:264 int./264 exh.
Advertised Intake Duration:304
Advertised Exhaust Duration:304
Advertised Duration:304 int./304 exh.
Intake Valve Lift with Factory Rocker Arm Ratio:0.548 in.
Exhaust Valve Lift with Factory Rocker Arm Ratio:0.548 in.
Valve Lift with Factory Rocker Arm Ratio:0.548 int./0.548 exh.
Lobe Separation (degrees):108
Intake Valve Lash:0.028 in.
Exhaust Valve Lash:0.028 in.
Computer-Controlled Compatible:No
Grind Number:Z-70
-
05-18-2015 07:55 AM #2
Bracket racing, Lopey idle. Needs 4000 stall converter, 4.88 to 5.38 rear axle gear ratio. Up to 850+ carb, Needs minimum 11.0:1 SCR.
Lifters 202H
Valve springs 6005 (requires heads be machined with Isky #568 hole saw) Dual with damper, chrome silicon. Inner part no. 906-AM, O.D. 1.005", I.D. 0.730". Outer part no. 305-DHS, O.D. 1.430", I.D. 1.070". Seat pressure 135# @1.750". Open pressure 285# @1.200". Rate per inch 275#, Coil bind 1.120", max net lift 0.550".
Spring shims #2
Steel retainers 507-ST
Poly locks PL-3/8
Rocker arms 204
Pushrods 203-HG (compatible with guide plate cylinder heads) (this means they're hardened).
Valve locks VL-32
Valve seals VS-11/32 (requires heads be machined with VST-11/32 cutter)
.Last edited by techinspector1; 05-18-2015 at 08:53 AM.
PLANET EARTH, INSANE ASYLUM FOR THE UNIVERSE.
-
05-18-2015 08:29 AM #3
Thank you!
Thank you Techinpactor 1!
You are very helpfull!
Ric
The main function of your little toe is to make sure all the furniture in the house is in the right place.
the Official CHR joke page duel