Anyone have any advise or pics of a good clean install?
Thanks
Printable View
Anyone have any advise or pics of a good clean install?
Thanks
a little more info. about your car and brake system would help.Quote:
Originally posted by iceburgh
Anyone have any advise or pics of a good clean install?
Thanks
Two ways to do it, either a mechanical switch or an inline pressure switch:
1) Mechanical switch is commonly one like you find under the dash of many cars, actuated by the pedal. Basically, when the pedal is not being depressed, it is resting on the push button of the switch, which is in the "open position" electrically. When you push on the pedal, the button on the switch pops out, causing the switch to close, and the lights go on.
2) Hydraulic inline pressure switch. You insert a Tee into the brake line somewhere (usually near the master cylinder) and when you push the pedal, the same hydraulic pressure that works your wheel cylinders closes the contacts in this inline switch, causing your lights to come on. These switches look similar to the little oil pressure switches you screw into your engine block, except they have 2 tabs for 2 wires.
I've always used the mechanical switch, because I am old fashioned, but we just used one of the hydraulic ones on my Sons '29, and I have to admit it makes a clean installation. We had heard you couldn't use these with silicone brake fluid, as it chews them up in short order, but a vendor at Turkey Run says the newer ones are designed for silicone. (I have had the same silicone brake fluid in my '27 for 12 years, and I will never use anything else, regardless of what some people say about spongy pedal feel, etc.) So we bought one of his switches, and will see how it works in the '29. For a tee, just use one of the "weatherhead" types you can pick up at any auto store.
If you decide to go with one of the mechanical ones, all you have to do is fab up a little bracket to hold the switch against the pedal, so that it releases when you push the pedal down.
Hope this helps.
If you really wanted to you could likely adapt the brake light switch from a 70's Ford. they actually sits on the peddle. You would need the appropriate pin size on the peddle for the ford mastercylinder push rod to go on, and probably have to cut the rod to legnth, but it shouldn't be too hard.
I prefer the in-line pressure switch, they work good, and eliminate a bit of the underdash clutter.
Because of how my pedal is in the car it would be yough so I would have to do something near the master cylinder.
Did not know they makea in line switch....guess that is the way to go.
Thanks for the help.
You can see more of what I am talking about here
http://photobucket.com/albums/v281/i...0street%20rod/
Hey, I used your link and checked out your gallery !!!! That is going to be one awesome car when you're finished!!!! Excellent work, congrats!!!! Keep us updated on the progress.... Any idea on paint and interior colors yet??????
Thanks 1st time I have ever done this from scratch I did a ton of work on my Vette but had a car to start with....thsi w=one here is from scratch and much more fun.Quote:
Originally posted by Dave Severson
Hey, I used your link and checked out your gallery !!!! That is going to be one awesome car when you're finished!!!! Excellent work, congrats!!!! Keep us updated on the progress.... Any idea on paint and interior colors yet??????
Colors will be silver on the bottom black on top with red,yello,orange traditional flames. Interior will be the same colors.
Keep checking that picture page and I will also be updating my website soon since I have sold the Vettes
www.iceburgh66.com
Should look good, great website btw, Ice.