Crane Cams stud girdles.

Ok,long story short.Sat I bent my rocker studs at the track.
So I went to the shop and grabbed a set of Crane studs and Girdles. I stared to install them today.Got the right side done.Now my valve cover wont clear. There a set of Edelbrock signature series Tall profile. Thay seem to be hitting on the inside bafflies. Can I remove the bafflies?? Thay look as if there only tack welded on. I figger a flat head screwdriver should pop them off.

Hmmmmmmmmmmm, a very BAFFELING question.
Go ahead and knock em out unless your using a pcv valve in one of the holes.

Done and done.Knocked them right out,and now thay fit. Thanks guys ..

OHHH MAN I JUST FOUND OUY YA CAN"T DO THAT !!!!!!!!!!!!

just kiddin(he-he)