I've got a basically stock 350 from a 1971 G30 chassis motor home. The only changes from stock are a melling MTC-1 cam kit (Dur. I - 204 Ex - 214 @ .050" Lift I - .420 Ex - .443), an Edlebrock Performer RPM intake, Edlebrock 600 CFM Carb, and a stock HEI ignition. I put this together a couple years ago before I really had any idea what worked with what. I know now that the cam and manifold are a little mismatched, I'll fix that later. My question is can someone run this on a desktop dyno and let me know approximately what HP and Torque it should be putting out. It's a 4 bolt block with a th350 transmission, '68 camaro eaton posi rear axle with 3.08 gears pushing a 3050# coupe with me in it.

I'd like to say that this forum and others like it are a wealth of information. I'm used to just trying things til I find something that works. Now with these forums, I've found out that in the past I've made a lot of mistakes putting these engines together and never knew it. I can see that at times I've spent a lot of time and money that was basically wasted. Thanks to these forums and the people on them that are willing to share their knowledge and experience, that won't happen again.

Thanks alot

Gary