Thread: Problem installing rockers
Threaded View
-
08-12-2022 09:11 PM #1
Problem installing rockers
350 5.7L , I recently changed one head, I used the same push rods and rockers. When I tightened down the nuts on the studs I reached zero lash before the stud cleared the top of the nut. Normally there’s about 1/4 inch of thread sticking out the top of the nut. What am I missing or what could be the cause? Stud height is the same on old head and new head, the only thing I’m thinking is the Spring tension on the valve. The lifters are sitting in the correct spot
The Australians have finally discovered the origin of the word 'Vegan.' Apparently it's an old Aboriginal word for 'Bad Hunter.'
the Official CHR joke page duel