Thread: Installing an HEI problems
Threaded View
-
08-25-2018 03:37 PM #1
Installing an HEI problems
I’m having trouble wit the installation of a new hei distributor from speedway. It’s going in a SB327 and I had it fireing and running using a hot wire from the ignition switch. I couldn’t advance the timing as the vacuum advance hits the intake. I was told to move it a tooth and try again. I did get it to fire, backfire, blow up and all kinds of stuff but not run. I then started all over , checked tdc and re-installed everything and even ran a hot directly from the battery. It does turn over really nice and smooth unlike it before but it won’t fire at all now. I have gas sand 12-10 volts while turning at the distributor. Any ideas???
The Australians have finally discovered the origin of the word 'Vegan.' Apparently it's an old Aboriginal word for 'Bad Hunter.'
the Official CHR joke page duel