Threaded View
-
07-22-2018 03:35 PM #1
350 marine engine rebuild help needed
I need to rebuild an engine in my Mastercaft boat. It has 1200h, which is A LOT for a boat engine (boat engines live a very tough life: a combination of high load and high RPM is what ultimately kills them).
Mastercraft uses marinized SBC 350 engines made by Indmar, with the following specs:
- 1 piece rear main seal
- engine block casting number 880
- vortex heads (170cc?)
- center bolt valve covers
- 8-bolt intake manifold
- plastic timing cover
The engine has multipoint fuel injection (it runs in an open loop, unlike road engines, which have closed loop systems with lambda sensors), Indmar ETX exhaust headers and is rated at 350hp (may be a bit optimistic, but that is what they claim).
Anyway, I have to rebuild that engine since it just died. I have seen a complete engine rebuild kits with marine gaskets etc on ebay for ~ $400.
Since those kits look to be assembled from pretty standard parts, I was wondering, if pouring $400-600 extra on some performance parts would make the engine last longer ?
If I could increase the RPM potential of that engine from max recommended 5000 RPM to 5500 RPM - all the better.
Is so, what would you recommend ?
Performance bearings ? Timing chain ? Valve springs ? Other ?Last edited by Elberoth; 07-22-2018 at 03:53 PM.
The main function of your little toe is to make sure all the furniture in the house is in the right place.
the Official CHR joke page duel