Welcome to Club Hot Rod! The premier site for everything to do with Hot Rod, Customs, Low Riders, Rat Rods, and more.

» Members from all over the US and the world!
» Help from all over the world for your questions
» Build logs for you and all members
» Blogs
» Image Gallery
» Many thousands of members and hundreds of thousands of posts!

YES! I want to register an account for free right now! p.s.: For registered members this ad will NOT show

Thread: Small Block Engine Identification?

       Tweet

Results 1 to 3 of 3

LinkBack
- LinkBack URL
- About LinkBacks
Thread Tools
Display
- Switch to Linear Mode
- Switch to Hybrid Mode
- Threaded Mode

Threaded View

02-04-2017 09:30 AM #1

RockTommy
CHR Junior sMember

Join Date

Feb 2017

Location

Haboro

Posts

2

Small Block Engine Identification?

Searching on the web and getting conflicting results...
Cast # 3932388
ID T0808HU
What do I have?
It is not in the original car...
Thanks!

Reply With Quote

« Previous Thread | Next Thread »

Posting Permissions

You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

New Forum Posts
- Moving on to next phase of frame reconstruction . Due to the Trans location I need to build a new center section for the X member. 1st cuts have been made . [/URL] I will use this 6"dia. ...
  
  New Project
  
  Today, 04:23 PM
- We did end up finding part of the problem, we did not put O-rings on the distributor shaft which was sending oil up the shaft instead of sending it to the lifters, adding O-rings quieted it down but...
  
  New guy from Utah.
  
  Today, 09:01 AM
- ".........Can't tell from the picture but could you mill some off the stock intake?......." There's a little bit there that could go........maybe at most an 1/8" which really isn't enough to do...
  
  1968 Plymouth Valiant 1st Gen HEMI
  
  Today, 08:51 AM
- Can't tell from the picture but could you mill some off the stock intake?
  
  1968 Plymouth Valiant 1st Gen HEMI
  
  Today, 07:34 AM
- We’re still moving forward. With the engine placed I got the motor mount perches tacked on to the K member. Naturally the welder started screwing up but fortunately the K member will be coming out...
  
  1968 Plymouth Valiant 1st Gen HEMI
  
  Today, 03:55 AM
Everywhere sidebar 1.4.1

Powered by vBulletin™ Version 4.1.3
Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.
Content Relevant URLs by vBSEO 3.6.0
Tabs System by vbSoporte - vBulletin en Español
vBulletin Styles developed by vBStyles.com

All material found at Club Hot Rod are copyright protected

Links monetized by VigLink